President Walker II Test Mode
Frequency Chart:
Yaesu FT-991/A & FTDX-1200 / 3000 / 5000 60m Modification
Alan 48 XL Multi Extended Bands
Midland M10 High Power & Frequency Unlock
Albrecht AE-5890EU New Version 2018
Yaesu FTDX-101D
Remove the top cover and the cover below it and look for the heatsink. Next to it is a MATRIX. Look for TX-OUT J2002-2″. KS5 is the second upper right solder point. Add solder point and full reset. EU Version
Kenwood TS-890s
tti – 1100 Modifications:
Move resistor from R43 to R42
This allows access to:
25615-30105 AM/FM known as band rU
25610-30110 AM/FM known as band PX
All A (Alpha Channels between 25645mhz to top end of 29mhz
Midland CT-200 Expansion:
Stabo XH9006e High Power / 120 Channels:
President JFK II A+ (Modification CB Radio NL) Matthijs
K-PO HR2800 Available Bands:
Midland M-10 Export Mode & High Power: http://tinyurl.com/y74jv6rh
Albrecht AE:6690 Channel & Power Modification: http://tinyurl.com/zcyjbdh
Anytone Apollo II Programming Software: http://tinyurl.com/zdu5ev8
Anytone AT-5555 v6
Midland / Alan 42 Multi:
President Johnny III & Harry III Service Manual: http://tinyurl.com/kgq556y
CRT Millenium Export Mode:
CRT Millenium Instruction Manual: http://tinyurl.com/hyyd6ct
Anytone Apollo 1 Manual: http://tinyurl.com/hpq8lly
Anytone AT-300M (crt-8040) Russian Language Export Mode:
Anytone Apollo II Manual: http://tinyurl.com/hky9rgt
Anytone AT-778v Set Up Software V1.01 : http://tinyurl.com/jl9cos6
Anytone AT-6666 (QX-6666) Software V2.01 (Anytone Branded Radio) http://tinyurl.com/h829gx3
Anytone AT-778 UHF / VHF Software: http://tinyurl.com/zlhjwsg
Programming Cable Schematic
Anytone AT-300 / 310m Schematic: http://tinyurl.com/zwajsa2
Anytone Apollo II Software. V1.01 :http://tinyurl.com/zdu5ev8
Super Galaxy Extended 10m Coverage
Intek M-495 Power & M-795 Power Modification
TTI TCB-1100 (Move resistor from one place to other) 25.610-30.110 / 25.615-30.105
Team TS-6m (26.515-27.855 AM / FM) Cut the wire and move the jumper
Intek M-120 Enable rU & Po
Thunderpole T1000 Enable rU & Po (Break the solder contact)
Intek M-150 Enable rU & Po (Join the solder point)
Lafayette Zeus (25.615-28.305) Turn on with ASC and FC Pressed (add the wire)
Intek M-799 Plus (25.615-30.105 / 25.610-30.110) Remove LK6
Intek M-130 Plus (25.615-30.105 / 26.510-30.110) Remove LK2
CRT-7900 Freq Expand
Yaesu FT-991 MARS/CAP Remove all screws, remove display and front panel, remove metal plate on back of front panel and solder JP3003 and reset
Lincoln II + : http://tinyurl.com/hrrk7gl
You will see some make big song and dance about the above. Why? I’ve no ideas..
Intek HR-2800 Schematic: http://tinyurl.com/hmy9cak
Intek HR-2800: rU Bands & Others: http://tinyurl.com/jmnqz69
CRT-2000
Intek M-799 Plus rU Mode Expansion:
Alinco SR8T/E Unlock Bottom cover off and solder A & B solder points
Emperor Ninja rU Mode: http://tinyurl.com/grkpah8
Albrecht AE-7500 Ham Mode: http://tinyurl.com/j2ylqly
Albrecht AE-6790 / 6891 Power & Channel Modifications: http://tinyurl.com/zj5b4w2
Albrecht AE-6690 Power & Country Options: http://tinyurl.com/zcyjbdh
Albrecht AE-6190 Country Options: http://tinyurl.com/h5mnk4x
President Lincoln II 400 Channel Mode: http://tinyurl.com/jqtdkgx
President Johnny II ASC Service Manual: http://tinyurl.com/zv6bjfn
Albrecht AE-6110 Manual All Languages: http://tinyurl.com/he48eyh
President Lincoln II + Software (Works Only On + V1.01) http://tinyurl.com/jefzdsx
CRT Superstar 3900n and CRT Superstar 3900 EL: http://tinyurl.com/zr6qqoc
Superstar 3900 Red / Jopix 3900: http://tinyurl.com/h7z5dd2
Cobra 29 LX-EU
Team MC-8 Multi Circuit Diagram: http://tinyurl.com/h354oly
Midland M-10 Possible 10w Power Mod: Cut K501 (not tested as no radio)
CRT 8040: Top Right hand side, cut the white wire and move the jumper
Ranger RCI-2950DX ERF2030 Conversion: http://tinyurl.com/h3esdfp
Midland G9 PMR Power Modification: http://tinyurl.com/hoale9k
Anytone AT-5555N 2014 Production: http://tinyurl.com/hgby23y
Maycom EM-27 Expansion rU Mode: http://tinyurl.com/z5xuag4
Alan 48 Plus Multi B (rU & Trimmers) http://tinyurl.com/gprrw7d
Alan 78 Multi B (rU & Trimmers) http://tinyurl.com/hcgd5g4
M-Tech Legend III rU Mode 120 channels: http://tinyurl.com/haw4zq8
M-Tech Legend II rU Mode 120 Channels: http://tinyurl.com/z7gvgm5
M-Tech Legend 1 rU Mode 120 Channels: http://tinyurl.com/gmb7un6
Stryker SR-955HPC Programming Software: http://tinyurl.com/jx3xnnf
Superstar 3900 Export Modification (Which version it works on unknown)
Jopix 2000 Export Modification:
Midland 8001 XT Modifications:
Albrecht AE-7500 Amateur Mode:
CRT Megapro Modification V2: http://tinyurl.com/gme6hae
CRT Megapro Software V3.01: http://tinyurl.com/h6wwpjw
CRT Superstar 6900 (N) Unlock:
CRT Superstar 9900 Version 1 Software (2014) http://tinyurl.com/jjc4oe7
CRT Superstar 9900 Version II Software (2015) http://tinyurl.com/hqhu2y6
CRT Superstar 7900 Version 1 Software: http://tinyurl.com/h4w4ksq
Danita 3000 Multi “Export Mode”
tti TCB-771 2w AM to 4w AM Power
tti 560 8 Watts Power:
Cobra 29LX EU Service Manual: http://tinyurl.com/hnqq5hh
CRT Megapro Software: http://tinyurl.com/h6wwpjw
tti 550 Bridge R50 For All The Goodies
tti 881 (Swap Resistor from filled place to empty space)
Tti TCB-880 Swap the resistor position
Midland M Zero Plus Export Modification:
Dynascan PMR Unlock channels & 2w Power: http://tinyurl.com/zxlrcfw
CRT Megapro Export Mode:
Cut the White wire and move the jumper, bands a-j and VFO Mode enabled
Icom IC-7300 Mars / CAP
Magnum1 Modifications:
CRT 4CF Enable Full Transmit:
Albrecht AE-6110 Adjustments (From Stefann) Should also be the same for the Anytone Smart CB
RM KL-7405 & KL 7505 Outside of 11m Transmit
Close the jumper and away you go
President Lincoln II V3 Echo Modification.
Some people complain about the large amount of echo even at the smallest settings in the menu. IF you are good at soldering then look at R630 and this is a 2k ohm resistor, swap it out with a 195k ohm resistor and the echo behaves much much better. Remember, invalidates warranty, small part, skill needed. Not for the faint of heart.
Albrecht AE-6110 & Anytone Smart (17-25w FM Power) Just FM not working in AM mode
Solder two legs together, in effect shorting it out. I have looked at photos from Klaus “HF-Doktor” and from http://www.srcb.ro online and this appears the only point which is the same. Limits life of your radio, invalidates warranty’s and is generally not a Smart way. But this is the power modification Photo: http://www.neuner.de (c)
Anytone AT-5555N & CRT Superstar 7900
Solder closed OP1
CRT 7900 Software:http://www.filedropper.com/ss7900setup10011 (limited time only, when expires its gone)
Albrecht AE-2990 AFS
AE2990AFS-Amateur-extension-to-Multi-Mode-Features
Stabo XM-4060e
Wire and Jumper
Team TS-6M LCD
Cut the wire and move the jumper. 26515-27855 AM/FM unlocked. Bands a, b, c
Danita 310m
Cut the wire and move the jumper. 25.1-30.1 AM/FM
Albrecht AE-4200 EU
Team MobileCom. Export Mode
Close OP1 and OP2 with solder, and for 0 ending and high power use the same modification as CRT One
CRT:
President:
Lincoln II (Only for initial pieces of first edition 1000 pieces to update to v2) Not for new models
Grant II Schematic:
Top Gun Quad 5 Export Mode and PCB Adjustments
Modification_Top_Gun_Quad-5_ENG
President Lincoln II Export Mode
Yaesu FT-991 MARS / CAP
Midland Base Camp 446
Grant II Premium: (HF-Doktor Information)
Hi, I wanted to know if you can in the crt ss 6900n v6 have the modification to do the 60 channels without losing the data when you do the reset? Thanks, Enrico
LikeLike
Ciao Enrico. Reset the radio and 60ch returns to 40 until programmed again via PC and software. Regards Simon
LikeLike
hi simon.I have a TTI 880 Max and i want to do a mod for 10 m or to change to export norm…can you help me pls..thks 73
LikeLike
Hi. TTI is in the blog, but newer version people had troubles as new maker but mod is the same. Regards Simon
LikeLike
Hello Simon looking for information on an Anytone AT-6666 for external S meter connection points, bhi DSP connection points, and connection points for an external VFO and schematics and also the service manual
Secondly looking for connection points for the bhi DSP module external S-meter connection points in an Alinco DX-SR8T
LikeLike
Anyone external S meter is on the blog
DSP Don’t have
Service Manual not released
Schematic on the blog too
Alinco most run the speaker, internal no idea
LikeLike
Hi Simon !
First off thanks for the information on the power mods for the President Walker 2 CB. It is much appreciated. Do you have any mods you can share for increasing the modulation ? Again thanks for your work and advice !!! Mike
LikeLike
Hi Mike. There is a way to increase it, it’s on the blog. Sadly I’ll not announce it as each radios values are different and too many armchair engineers have messed up radios by not having test gear, not writing down values before modifying the equipment.. Then when they’ve a paperweight they cry!
Regards
Simon
LikeLike
Hi Simon,
I completely understand your concerns about posting the mods for increasing modulation for the President Walker. I will not be doing this mod myself. I have an an experienced shop doing it for me. He told me if I could research the mod he would do it for me. He does not have the time to do the research, I looked and looked but I could not find it. I found the service manual and a link to a Polish company that sells the radio with the mods. Would you please consider emailing me the mod ? I promise, he is a great radio tech and has all the correct equipment. If something went wrong I certainly would not hold you responsible in any way. If you don’t feel comfortable, then that is OK too. No hard feelings !!
Mike
LikeLike
Hi Mike. The english service manual is on here and its got the way in it.
Regards
Simon
LikeLike
Hi Any power mods for the President Walker 2 Radio ? Thanks !
LikeLike
Yep
LikeLike
Hello, Simon
Is there a way to add an external s-meter to a CRT SS6900 (at-5555 and so on..). WHERE can I take the signal?
Thanks a lot.
Patrice
LikeLike
Hi Patrice. Yes I know it’s possible via 1 tap and using CW socket but sadly it’s sold as a modification from businesses and I don’t have it here 🙁
Only have 6666 mod: https://simonthewizard.com/2020/10/18/new-at-6666-external-s-meter/
Regards
Simon 🧙♂️
Maybe ask on 6900 forum on Facebook? Maybe someone has the modification
LikeLike